Geltimer for Powder
Determination of the gel time of powder coatings
The gelation of powder coatings in accordance with DIN ISO 8130-6 (DIN 55 990) is defined as the amount of time required to transfer a specific volume of a powder coating upon melting under defined conditions to a non-deformable state.
To determine these gel time of powder coating, our Heating Block PL 2 is used according DIN ISO 8130-6 with a spherical depression (trough).
With the temperature control unit with integrated stopwatch TCT-1, the temperature of the heating block is optimally controlled. In a heated block PL 2 is a security-temperature limiter installed with 270 ° C. This switches on reaching the filament voltage from irreversible.
Heating block PL
|Temperature range||30,0 °C … 200,0 °C|
|Power supply||230 V / 50 Hz or 115 V / 60 Hz, ± 10 %|
|Heat power||550 W|
Temperature control unit TCT-1 with stopwatch
|Power supply||100 …240 VAC, 50 / 60 Hz|
|Power consumption||600 VA with connected heating block PL|
|Connectors||8 Pole Binder connector for connecting the heating block PL|
|Temperature range||30°C … 200 °C (on request 250 °C)|
|Additional measurement||1 x type K, EN 60584, for the surface temperature|
|Main switch||on the rear panel|
|Fuses||2 pcs. F3,15A L250 VAC|
DIN ISO 8130-6 (DIN 55 990)